KRYSTALIA: Decorative System Crystal Effect
METHODS OF APPLICATION
Surface preparation
Sandpaper and dust any imperfections with STUCCOMURO and apply 1 coat of FISSATIVO UNIVERSALE which should be correctly diluted with water at a ratio of 1:5 up to 1:10 according absorption of the surface.
Leave to dry for at least 4 hours and apply 1 or 2 coats of PRIMER S, which is special slightly rough either white or slightly colored, correctly diluted (consult the Technical data sheet) leaving 4 to 5 hours between each coat. (photo 1)
Application
Spread a layer of KRYSTALIA with a SPALTER DECORA’ tool on the surface (photo n.2) ) by using irregular movements like cris crossing brush marks (photo n.3). After drying about 6 hours, repeat the same procedure as the first coat (photo n.4) in order to obtain the desired finish and an excellent coverage of the surface.
The KRYSTALIA finish can be clearly seen when the entire surface has completely dried about 4 to 5 hours after the application.
Packaging and colouring
KRYSTALIA COMPONENT A: packaging Lt. 2,5 + KRYSTALIA COMPONENT B: packaging gr. 100
ARTHE CONCENTRATO: packaging of ml.70
Pour KRYSTALIA COMPONENT B into the bucket of KRYSTALIA COMPONENT A and hand mix.
Each color in our color chart has been divided into 4 different shades, each one corresponds to a letter E, F, G, H, in order to obtain the desired color add in 2,5 Lt. di KRYSTALIA NEU TRAL BASE the quantity of ARTHE CONCENTRATO according to the following chart:
|
|
Art. ...E
|
Art. ...F
|
Art. ...G
|
Art. ...H
|
|
Aggiungere 3X70 ml.
|
Aggiungere
1X70 ml.
|
Aggiungere
(*) 22 ml
|
Aggiungere
(*) 8 ml
|
|
|
(*): The amount obtainable with the syringe measure which is available from us.
Varying the dose of ARTHE CONCENTRATO, allows you to get an unlimited range of colors.
KRYSTALIA can also be colored by using GLOBAL TINTING SYSTEM by SPIVER
|
|
Yield KRYSTALIA:
9-10 square meters per /Lt. with 2 coats
|
|
|
