DECORA': old fashioned effect wall finish decorative system
METHODS OF APPLICATION
Surface preparation
Sandpaper, dust and level any imperfection using Stuccomuro or Polistuck and then apply one coat of FISSATIVO UNIVERSALE which should be diluted in water at a ratio of between 1:1 up to 1:10 this depends on the absorption of the surface to be applied.
Leave it to dry for at least 4 hours and then apply 2 coats of PRIMER “S” (which is a special primer slightly rough of white colour, containing grains of low thickness 0,1 millimeter. and it enables you to obtain the effect you can see in our catalogue) or if you want to obtain a very fine finish, apply two coats of SPIVER GENYUS SPECIAL correctly diluted (consult the technical data sheet) leave an inter val of 4-5 hours between each application (photo n.1).
Application
The application of DECORA' is extremely easy.
Spread DECORA' using a glove or a flat paint brush using circular movements (photo n.2). The final effect can be obtained by going back over the applied area (after 15 minutes) striking the surface gently an seen in photo n.3 .
Packaging and colouring
DECORA' NEUTRAL BASE: Lt.4
DECORA' NEUTRAL GOLD BASE: Lt.4
ARTHE CONCENTRATO: ml.70
Each article in our colour chart is divided into 4 different grades, each one corresponds to a letter E, F ,G ,H. To obtain the colour desired add the quantity of ARTHE CONCENTRATO indicated in the chart below to 4Lt. of Decorà Neutral.
|
|
Art. ...E
|
Art. ...F
|
Art. ...G
|
Art. ...H
|
|
Add 3X70 ml.
|
Add 1X70 ml.
|
Add (*) 22 ml.
|
Add (*) 8 ml.
|
|
|
(*): the amount obtainable with the syringe measure which is available from us.
Varying the dosage of ARTHE CONCENTRATO, allows you get an unlimited range of colours
Yield:
About 7-8 mq. / Lt.
|
|
|
