Atr

Perlscent decorative system
Surface preparation:
Sandpaper, dust and level any imperfection using Stuccomuro and then apply one coat of FISSATIVO UNIVERSALE which should be diluted in water at a ratio of between 1:1 up to 1:10 this depends on the absorption of the surface to be applied. Leave it to dry for at least 4 hours and then apply 2 coats of PRIMER “S” of the colour you desire ( a special slightly rough white primer, it contains ver y fine grains of about 0,1mm which allows you to get the effect
Application:
DECORA’ DeLuxe is an extremely easy product to apply.
Spread DECORA’ DeLuxe with a “Spalter Decorà” or glove in a circular way as you can see in (Photo N. 2 - Photo N.3); the final effect can be obtained by gently touching the applied surface with a special Decorà Trowel, after about 30 minutes (Photo N. 4)
The finished effect of DECORA’ DeLuxe can be clearly seen 4 to 5 hours after the finished application.
Packaging and colouring:
PRIMER S: packaging of Lt.4
DECORA’ DeLuxe: packaging of Lt. 2
ARTHE PERLA: packaging of Ml.600
ARTHE CONCENTRATO: packaging of Ml.70
- For the colouring of PRIMER “S” you must add to each bucket of Lt.4
the quantity of ARTHE CONCENTRATO indicated in the chart below:
Primer
"S" Z-34
Primer
"S" Z-35
Primer
"S" Z-36
Primer
"S" Z-37

Add1X70 ml.
of A.C.516

Add
1X70 ml.
di A.C.511
+ 1x70 ml di A.C. 514

Add 1X70 ml.
of A.C.523
Add 2X70 ml.
of A.C.517
Primer
"S" Z-38
Primer
"S" Z-39
Primer
"S" Z-40

Add 3X70 ml.
of A.C.513

Add
1X70 ml.
of A.C.518

Add 1X70 ml.
of A.C.515
Add to each bucket of DECORA’ DeLuxe BASE of Lt.2, one pack of ARTHE PERLA of Ml.600 and mix manually.
Yield:
PRIMER “S” : 7 – 8 m²./ Lt. (1 coat ); 4 – 5 m² / Lt. (2 coats);
DECORA’ DeLuxe: 10 m² / Lt.

 

 
20:03:57