Atr
VELATURA “Classic”: Velatura silossanic glazing for smooth surfaces.
METHODS OF APPLICATION
Surface preparation
Sandpaper, dust and level any imperfection using Stuccomuro or Polistuck and then apply one coat of UNIVERSAL FISSATIVO which should be diluted in water at a ratio of between 1:R up to 1:10 this depends on the absorption of the surface to be applied.
Leave it to dry for at least 4 hours and then apply 2 coats of Spiver REOSAN OPACO correctly diluted (consult the technical data sheet) leave an interval of 4-5 hours between each application (photo n.1) .
By using Spiver Reason Opaco which is a low absorption paint, it makes it much easier the application of the VELATURA.
Application
The application of VELATURA is extremely easy.
Spread the product homogeneously using a flat paint brush (photo n. 2) and straight away using a sponge or glove go back over the surface in using circular movements (photo n.3).
Packaging and colouring
VELATURA NEUTRAL BASE: Lt.4
ARTHE CONCENTRATO: ml.70
Each article in our colour chart is divided into 4 different grades, each one corresponds to a letter E, F ,G ,H.
To obtain the colour desired add the quantity of ARTHE CONCENTRATO indicated in the chart below to 4Lt. of Velatura Neutral.
Art. ...E
Art. ...F
Art. ...G
Art. ...H
Add 3X70 ml.
Add 1X70 ml.
Add (*) 22 ml.
Add (*) 8 ml.
(*): the amount obtainable with the syringe measure which is available from us.
Varying the dosage of ARTHE CONCENTRATO, allows you get an unlimited range of colours
Yield:
about 8 mq. / Lt.

 

 
20:03:57